Summary
In a manual transmission rear wheel drive vehicle, the gear train is built on three pillars: the input shaft, the intermediate shaft and the main shaft.
In a manual transmission rear wheel drive vehicle, the gear train is built on three ejes.El input shaft extends from the front of the transmission. A section parallel external toothing meshing with internal splines of the clutch plate accionado.Un main drive gear is an integral part of the shaft. In constantly meshing engagement with a gear on a counter shaft having a number of cogs formed in él.Estos gears mesh with mating gears on the main shaft or output. These mainshaft gears are supported on bearings on the shaft. They can rotate without turning the motor shaft gear salida.Cada has an external toothed section on one side. The teeth are facing aent case can slide in any direction to engage the external teeth on the right gear. This locks the gear through the sleeve and hub, the shaft of occurrence motor.Antes coupling components, a device synchronized between the sleeve and the gear of the constantly meshed gears sincroniza.Los have cutting teeth in a helix at an angle to the centerline of engranaje.Esto reduced gear noise and distributes the load more evenly as several teeth are in contact at any momento.Dientes in reverse idler are usually cut straight or sprockets, cut parallel to the centerline of engranaje.Cuando reverse is selected, this is connected with reverse idler gears on the intermediate shaft coupling and shaft reverse idler engine.The swiveling normal axis fixed in the housing. The drive is transferred from one shaft to the other, and reversing the direction of rotation of the main shaft
0 Komentar untuk "Gearbox Layouts"